Panoramic sunroof (Tourer)
This device comprises a tinted glass panoramic surface 1 to improve brightness and vision in the passenger compartment.
It is fitted with an electrical blind 2 to help maintain a comfortable temperature.
Sequential opening
Press control A.
Pressing to the 1st notch allows you to open the panoramic sunroof step by step.
Pressing to the 2nd notch allows you to fully open the panoramic sunroof.
The panoramic sunroof stops in the closest pre-defined position (11 positions) as soon as you release the control.
Sequential closing
Press control B.
The panoramic sunroof stops as soon as you release the control.
Anti-pinch
If the panoramic sunroof meets an obstacle whilst closing, it stops and opens partially again.
You must re-initialise the anti-pinch function within 5 seconds of the panoramic sunroof stopping :
- Press control B until the panoramic sunroof is fully closed (closing in steps of a few centimetres).
Notes :
After a battery disconnection, or if there has been a malfunction, you have to re-initialise the anti-pinch function :
- press control A to the 2nd notch (fully open), - wait until the panoramic sunroof is fully open, - press control A for at least 3 seconds.
If the panoramic sunroof opens randomly during a closing operation, and straight after the panoramic sunroof stops :
- Press control B until it closes fully.
During these operations, the anti-pinch function does not operate.
In the event of anything being caught when the panoramic sunroof is moving,
you must reverse the movement of the panoramic sunroof. To do so, reverse the position
of the control.
When the driver is operating the panoramic sunroof, he or she must always make sure
that the passengers are not preventing it from closing properly.
The driver must ensure that his passengers are using the panoramic sunroof correctly.
Pay special attention to children when operating the panoramic sunroof.
See also:
Bonnet release
Bonnet
This operation should only be performed while the vehicle is stationary.
Open the door.
To unlock, pull release lever A.
Lift up lever B, then raise the bonnet.
Note: The panel may be ...
Recommendations for ventilation and air
conditioning
In order for these systems to be fully effective, follow the operation and
maintenance guidelines below:
To obtain an even air distribution, take care not to obstruct the
exterior
air intake ...
Rear lamps (tourer)
Rear lamp on wing
Remove the lateral boot trim A.
To do so :
1 Pull it towards towards the inside of the boot.
2 Pull it upwards.
3 Disconnect the connector B.
4 Unscrew the fixing screw C.
...