Front lamps, directional headlamps
- Additional headlamp (main beam)
- Headlamp dipped beam/ Main beam
- Sidelamp
- Direction indicator
The halogen bulbs should not be changed until they have been off for a few minutes (risk of serious burns). Do not touch the new bulb directly with your fingers; use a lint-free cloth. It is essential that only anti U.V. type bulbs are used in order not to damage the headlamp. When using a high-pressure jet wash for cleaning the vehicle, don’t persist on the headlamps and other lamps, particularly around their edges, so as to avoid damaging their lacquer finish or seals.
If the headlamp has this symbol, any operation involving changing a Xenon D1S bulb must be carried out by the CITROËN network (risk of electrocution). It is recommended to change both bulbs at the same time if one is faulty.
Main beam
Pull the rubber stops. Disconnect the bulb. Disengage the ends of the retaining spring to release it. Remove the bulb. Bulb: H1 For vehicles not equipped with Xenon headlamp bulbs.
Headlamp dipped beam
Pull the rubber stops. Disconnect the bulb. Disengage the ends of the retaining spring to release it. Remove the bulb. Bulb: H7
Note: On HDi 90 and 110 engines, unclip the cover for access to the left hand headlamp.
Front lamps
Front direction indicator
Rotate the bulb-holder A by a quarter turn and pull. Press to disengage the bulb. Bulb: PY 21 W yellow.
Front lamps, directional headlamps
Sidelamp
Disconnect the connector by pressing on the metallic part. Rotate the bulb-holder B by a quarter turn and pull on the bulb. Bulb: W 5.
Direction indicator side repeaters in the rear view mirrors
To change the side repeater bulb, press firmly in the area indicated by the arrow, then pull on the side repeater.
Front foglamps
Consult your CITROËN dealer.
Interior lamp
Unclip the transparent cover of the interior lamp to reach the bulb. Bulb: W 5 W
Spotlamps
Unclip the cover of the interior lamp, then if necessary the partition for the spotlamp concerned, to access the bulb. Bulb: W 5 W
Boot lighting
Unclip the lens unit to access the bulb. Bulb: W 5 W
Sill lighting
Unclip the headlamp to access the bulb. Bulb: W 5 W
Glovebox lighting
Unclip the lens unit to access the bulb. Bulb: W 5 W
See also:
One-touch electric windows
There are two methods
of operation:
- manual mode
Press or pull the switch gently.
The window stops as soon as the
switch is released.
- automatic mode
Press or pull the switch fully.
Th ...
Boot lighting
This comes on automatically when the
boot is opened and switches off automatically
when the boot is closed.
Different lighting times are available:
- when the ignition is off, approximately
ten ...
Electric control panel
The heating/ventilation or air conditioning
systems can only operate with the
engine running.
1. Temperature adjustment
Turn the dial from blue
(cold) to red (hot) to adjust
the temperature ...