Luggage cover blind (Tourer)
To install :
Position the left-hand end of the luggage-cover blind in its housing A behind the rear benchseat.
Squeeze the blind’s control 1 and position it in place in its housing B to the right-hand side.
Release the control to secure the luggage-cover blind.
Unroll it until it locks into place on the boot pillar.
To fold up :
Press gently on the handle (PRESS ). The luggage-cover blind rolls up automatically.
The moveable section C can be folded up along the backrest of the rear benchseat.
To remove :
Press gently on the handle (PRESS ). The luggage-cover blind rolls up automatically.
Squeeze control 1 and lift up the luggage-cover blind to the right then to the left to remove it.
See also:
Deactivation
In exceptional conditions (starting a vehicle
which is bogged down, stuck in
snow, on soft ground...), it may be advisable
to deactivate the ASR and ESP
systems, so that the wheels can move
freel ...
Fuel consumption
These consumption values are established in compliance with European directive
80/1268/CEE. They can vary depending on how the vehicle is driven, on the prevailing
traffic conditions, on weather ...
Closing
Take the stay out of the support
notch.
Clip the stay in its housing.
Lower the bonnet and release it at
the end of its travel.
Pull on the bonnet to check that it is
fully latched.
...