Rear lamps (saloon)
Rear lamp unit
Identify the failed bulb.
Bulbs:
A S top-lamps and sidelamps:
P 21 W / 5 W
B S idelamp: R 5 W
C R eversing lamp: H 21 W
D Foglamp: H 21 W
E Direction indicator: P 21 W
Rear lamp on boot
1 Open the boot.
2 Using a flat screwdriver, remove the 3 clips which fix the trim in the lamp
area.
3 Partially remove the trim F.
4 Disconnect the connector G.
5 Detach the bulb holder H.
6 Replace the bulb.
7 Replace the bulb holder H.
8 Connect the connector G.
9 Replace and fix the trim F with its clips.
In some climatic conditions, mist may appear on the headlamp / indicator lenses.
This is normal and will disappear (e.g. after the lamps have been on for a few minutes).
If not, contact a CITROËN dealer.
Rear lamp on wing
1 Remove the lateral boot trim flap A. To do so, pull it towards the inside of the boot, then pull it upwards.
2 Disconnect connector B.
3 Unscrew the 2 fixings C.
4 Remove the lamp from its housing.
5 Detach the bulb holder D.
6 Replace the bulb.
7 Replace the bulb holder D.
8 Place the lamp in its housing.
9 Screw in the 2 fixings C.
10 Connect connector B.
11 Refit the trim A.
Note: You can use the spare wheel jack handle to screw or unscrew the fixings C.
Rear lamp unit
Identify the failed bulb.
Bulbs:
A S top-lamp and sidelamp :
P 21 W / 5 W
B S idelamp : R 5 W
C R eversing lamp : H 21 W
D Foglamp : H 21 W
E Direction indicator: P 21 W
Rear lamp on boot
1 Open the boot.
2 Using a flat screwdriver, remove the 3 clips which fix the trim in the lamp
area.
3 Partially remove the trim F.
4 Disconnect the connector G.
5 Detach the bulb holder H.
6 Replace the bulb.
7 Replace the bulb holder H.
8 Connect the connector G.
9 Replace and fix the trim F with its clips.
In some climatic conditions, mist may appear on the headlamp / indicator lenses.
This is normal and will disappear (e.g. after the lamps have been on for a few minutes).
If not, contact a CITROËN dealer.
See also:
Trip computer
To obtain display and selection of the different types of information, give short
presses on the end of the windscreen wiper stalk.
To reset trip computer information to zero, press continuously ...
Access to the tools
The towing eye is installed in the boot
under the fl oor.
To gain access to it:
open the boot,
raise the fl oor,
remove the polystyrene storage box,
remove the towing eye from the
hold ...
RDS sytem
Using the RDS (radio data system) function on FM
The majority of FM radio stations use the RDS system. The radio in your vehicle
has this system. The RDS system enables these stations to transmit n ...