Indicator and warning lamps

Citroen C3 / Citroen C3 Owner's Manual / Instruments and controls / Petrol - diesel manual or automatic gearbox instrument panels / Indicator and warning lamps

Visual indicators informing the driver that a system is in operation (operation or deactivation indicator lamps) or of the occurrence of a fault (warning lamp).

When the ignition is switched on

Certain warning lamps come on for a few seconds when the vehicle's ignition is switched on.

When the engine is started, these same warning lamps should switch off.

If they remain on, before moving off, refer to the information on the warning lamp concerned.

Associated warnings

The switching on of certain warning lamps may be accompanied by an audible signal and a message on the multifunction screen.

Operation indicator lamps

If one of the following indicator lamps comes on, this confi rms that the corresponding system has come into operation.

The warning lamps may come on continuously (fixed) or flash.

Certain warning lamps may come on in two different modes. Only by relating the type of lighting to the operating status of the vehicle can it be ascertained whether the situation is normal or whether a fault has occurred.

Deactivation warning lamps

Deactivation warning lamps

If one of the following warning lamps comes on, this confi rms that the corresponding system has been switched off intentionally.

Warning lamps

Warning lamps

When the engine is running or the vehicle is being driven, the switching on of one of the following warning lamps indicates a fault which requires action on the part of the driver.

Any fault resulting in the switching on of a warning lamp must be investigated further by reading the associated message on the multifunction screen. If you encounter any problems, do not hesitate to contact a CITROËN dealer.

Service indicator

    See also:

    Diesel engines HDi 173 - V6 HDi 208 (with particle filter)
    1. Screen wash and headlamp wash reservoir. 2. Power steering and suspension fluid reservoir. 3. Engine coolant reservoir. 4. Engine oil gauge. 5. Engine oil topping-up. 6. Air filter. 7. Brak ...

    Trip computer
    System which provides current information concerning the route travelled (range, consumption…). ...

    Changing a wiper blade
    Procedure for replacing a worn wiper blade with a new one without the use of tools. Before removing a front wiper blade Within one minute after switching off the ignition, operate the wipers ...