Reinitialisation
In the event of a malfunction you have to reinitialise the operation of the electric windows:
- release the switch and pull it again until the window closes completely,
- hold the switch for approximately one second after closing,
- press the switch to lower the window automatically.
The safety anti-pinch function is not active during these operations.
Always remove the key from the ignition when leaving the vehicle, even for a short time.
In the event of contact during operation of the windows, reverse the movement of the window. To do this, press the switch concerned.
When the driver operates the passenger electric window switches, they should ensure that no one is preventing correct closing of the windows.
The driver should ensure that passengers use the electric windows correctly.
Be aware of children when operating the windows.
See also:
Engine oil level indicator
System which informs the driver whether
the engine oil level is correct or not.
This information is indicated for a few
seconds when the ignition is switched
on, after the service information.
...
Manual parking brake
Parking brake
The parking brake is engaged, with the vehicle stationary, by pulling on the
lever with a force appropriate to the slope.
To facilitate the action on the lever, you are recommended ...
Remote control
Note:
The simultaneous use of other high frequency equipment (mobile telephones, domestic
alarms, etc.) may momentarily hinder the operation of the remote control.
If there is a permanent fault, ...