Manual controls
The lighting commands are issued directly by the driver by means of the ring A and the stalk B .
Model without AUTO lighting
Model with AUTO lighting
A. Main lighting mode selection ring, with:
lamps off,
automatic switching on
of the lamps,
sidelamps only,
dipped headlamps or
main beam headlamps.
B. Stalk for switching headlamps by pulling: dipped headlamps/main beam headlamps.
In the lamps off and sidelamps modes, the driver can switch on the main beam headlamps temporarily ("headlamp fl ash") by maintaining a pull on the stalk.
See also:
Engine oil level indicator
System which informs the driver whether
the engine oil level is correct or not.
This information is indicated for a few
seconds when the ignition is switched
on, after the service information.
...
Speed limiter
This driving assistance device allows you to select a maximum speed that you
wish not to exceed. This has to be a speed greater than 30 km/h (approx. 20 mph).
The speed limiter controls are loca ...
Changing a fuse
Before changing a fuse, the cause of the
failure must be identifi ed and rectifi ed.
Identify the faulty fuse by checking
the condition of its fi lament.
Correct
Incorrect
Use the special ...