Closing
- Take the stay out of the support notch.
- Clip the stay in its housing.
- Lower the bonnet and release it at the end of its travel.
- Pull on the bonnet to check that it is fully latched.
See also:
Programming
Various automatic wiper control modes
are also available according to the following
options:
- automatic wiping for the windscreen
wipers,
- rear wiping on engaging reverse
gear.
Model with int ...
Vehicle identification
All original CITROËN replacement parts are available from CITROËN. It is in the
user’s interest, for his safety and for the sake of the warranty, to reject all
other parts. Fitting par ...
Operating faults
If there is an operating fault, when
reverse gear is engaged the service
warning lamp comes on, accompanied
by an audible signal (short beep) and a
message on the multifunction screen.
In bad or ...