Starting using another battery
Citroen C3 / Citroen C3 Owner's Manual / Practical information / Battery / Starting using another battery
- Connect the red cable to the positive terminal (+) of the fl at battery A , then to the positive terminal (+) of the slave battery B .
- Connect one end of the green or black cable to the negative terminal (-) of the slave battery B .
- Connect the other end of the green or black cable to the negative terminal (-) of the fl at battery A .
- Start the slave vehicle.
- Operate the starter of the broken down vehicle and let the engine run.
- Wait until the engine returns to idle and disconnect the cables.
See also:
Programming
Turn thumb wheel 1 to the "LIMIT"
position: the speed limiter mode
is selected but is not switched on
(PAUSE).
You do not have to switch the speed
limiter on in order to set the speed ...
Dashboard lighting rheostat
The rheostat is active if the sidelamps are on and applies to:
- the instrument panel
- the displays
The desired brightness is selected via control A or by pressing control B.
With control B, ...
Instrument panel
On opening the driver’s door or unlocking with the remote control, for approximately
30 seconds the instrument panel is activated, displaying the mileage recorders and
if applicable, the maintenan ...