Changing a wiper blade
Procedure for replacing a worn wiper blade with a new one without the use of tools.
Before removing a front wiper blade
- Within one minute after switching off the ignition, operate the wipers stalk to position the wiper blades in the centre of the windscreen.
Removing a front or rear wiper blade
- Raise the corresponding wiper arm.
- Unclip the wiper blade and remove it.
Fitting a front or rear wiper blade
- At the front, check the size of the wiper blade as the shorter blade is fi tted on the right-hand side of the vehicle.
- Put the corresponding new wiper blade in place and clip it.
- Fold down the wiper arm carefully.
After fitting a front wiper blade
- Switch on the ignition.
- Operate the wipers stalk again to park the wiper blades.
See also:
Operating faults
If there is an operating fault, when
reverse gear is engaged the service
warning lamp comes on, accompanied
by an audible signal (short beep) and a
message on the multifunction screen.
In bad or ...
Lighting
Ring A
Lighting off.
Automatic lighting.
Sidelamps.
Dipped/main beam headlamps.
Ring B
Rear foglamps.
or
Front and rear foglamps. ...
Dashboard lighting rheostat
The rheostat is active if the sidelamps are on and applies to:
- the instrument panel
- the displays
The desired brightness is selected via control A or by pressing control B.
With control B, ...