Rear lamps (tourer)

Rear lamp on wing
Remove the lateral boot trim A.
To do so :
1 Pull it towards towards the inside of the boot.
2 Pull it upwards.

3 Disconnect the connector B.
4 Unscrew the fixing screw C.
5 Remove the lamp from its housing.

6 Detach the bulb holder D.
7 Replace the faulty bumb.
8 Replace the bulb holder D.
9 Place the lamp in its housing.
10 Screw in the fixing screw C.
11 Connect the connector B.
12 Refit the trim A.
Note : You can use the spare wheel jack handle to screw or unscrew the fixing screw C.
See also:
Instrument panel
A. With the ignition on, the fuel gauge
bars for the fuel remaining should
light up.
B. With the engine running, the associated
low level warning lamp should
switch off.
C. With the ignition o ...
Audible and/or visual rear parking assistance
This system consists of four proximity
sensors, located in the rear bumper.
This detects any obstacle (person, vehicle,
tree, gate, etc.) behind the vehicle,
except obstacles located just below ...
Languages
Once the "Languages" menu has been
selected, you can change the language
used by the display (Français, Italiano,
Nederlands, Portugues, Portugues-
Brasil, Deutsch, English, Espan ...






