HDi 90 and HDi 110 FAP engines
- Fill the fuel tank with at least fi ve litres of diesel.
- Open the bonnet.
- Depending on version, unclip the cover to gain access to the repriming pump.
- Squeeze and release the repriming pump until fuel appears in the transparent pipe with the green connector.
- Operate the starter until the engine starts.
- Depending on version, put the cover back in position and clip it in place.
- Close the bonnet.
If the engine does not start at the fi rst attempt, do not try again.
Operate the repriming pump again, then the starter.
See also:
Air treatment
The incoming air follows various routes
depending on the controls selected by
the driver:
- direct arrival in the passenger compartment
(air intake),
- passage through a heating circuit
(heating ...
Manual adjustments
Forwards-backwards adjustment
Raise the control and slide the seat
forwards or backwards.
Driver's or passenger's seat height
adjustment
Pull the control upwards to raise
or push it downward ...
Radio source
Notes on radio reception
Your radio will be subject to certain phenomena that are not encountered by domestic
systems.
The reception of AM and FM signals may suffer from interference, which is cau ...






