Lighting controls
1 Off
2 Automatic lighting
3 Sidelamps
4 Dipped beam/Main beam
All lighting off
Turn the barrel A forward.
Automatic lighting of headlamps
Sidelamps and dipped beams come on automatically in conditions of poor ambient light or when the wipers are in continuous operation.
They go out as soon as the light is once again sufficient or approx. 5 minutes after the wipers have stopped.
To activate this function, place control A on position 2.
Do not cover the brightness sensor, which is visible from the outside of the windscreen, behind the interior rear view mirror.
Turn the barrel A forward.
Sidelamps on
Turn the barrel A forward.
Dipped beams/ main beams on
Pull the stalk towards you to change from dipped beam to main beam and vice versa.
Lights left on
An audible warning signal is triggered on opening the driver’s door, ignition off, to indicate that the vehicle’s lights are still on.
It stops on closing the door, switching off the lights or switching on the ignition.
There is no signal if automatic lighting or guide-me home lighting is activated.
Guide-me-home lighting
This function leaves the headlamps on temporarily to assist your exit in low light conditions.
This function is activated:
• Manually by pulling the lighting stalk towards you, ignition switched off.
• Automatically, provided that:
- the automatic headlamp lighting has been activated,
- the guide-me-home lighting has been activated. For this, select in the "Main menu",
then in "Personalisation- Configuration", the lighting and signalling sub-menu and
then activate the function.
See "Multifunction displays".
Note: It is possible to modify the duration of the guide-me-home lighting (approx. 60, 30 or 15 seconds) in the menu "Personalisation-Configuration".
For display A the period is fixed (approximately 30 seconds)
Vehicles with front and rear foglamps (Ring B)
They operate when sidelamps, dipped
beams or main beams are switched on.
For a vehicle equipped with rear foglamps:
- 1st notch forwards: switches on rear foglamps.
- 1st notch rearwards: switches off rear foglamps.
For a vehicle equipped with front and rear foglamps:
- 1st notch forwards: switches on front foglamps.
- 2nd notch forwards: switches on rear foglamps.
- 1st notch rearwards: switches off rear foglamps.
- 2nd notch rearwards: switches off front foglamps.
Note:
The rear foglamps must only be used when visibility is severely reduced (fog, snow).
In conditions of poor visibility, if the ambient brightness does not trigger the automatic lighting, it is up to you to switch on your dipped beams manually, as well as your foglamps.
See also:
Mats
Removable component which protects
the carpet against exterior dirt.
Fitting
When fi tting the mat for the fi rst time,
on the driver's side, use only the fi xings
provided in the wallet attached ...
Frequently-asked questions
The table below provides answers to the questions that are asked the most frequently.
...
Diesel fuel consumption
with "Michelin Energy Saver" tyres (15 and 16 inch wheels)
These consumption values are established in compliance with European directive
80/1268/CEE. They can vary depending on how the ...