Snow guard
SNOW GUARD
Moveable device which prevents the accumulation of snow by the radiator cooling fan.
Fitting
Bring the 2 sections of the snow guard up to the upper and lower sections of the front bumper.
Press on the surround to clip in one by one the fixing clips.
Remove
Using a screwdriver, lift it up to detach each fixing clip one by one.
Before fitting
After fitting
It is essential to remove the snow guard:
When the outside temperature exceeds 10 °C.
When towing.
When driving at speeds of over 120 km/h (approximately 75 mph).
See also:
Putting the wheel back in place
Put the wheel back in its housing.
Unscrew the yellow central bolt by a
few turns then put it in place in the
centre of the wheel.
Tighten fully until the central bolt
clicks to retain th ...
Automatic lighting of hazard
warning lamps
When braking in an emergency, depending
on the deceleration, the hazard
warning lamps come on.
They will switch off automatically the
fi rst time you accelerate.
If they do not, press button A to ...
Instrument panel
A. With the ignition on, the fuel gauge
bars for the fuel remaining should
light up.
B. With the engine running, the associated
low level warning lamp should
switch off.
C. With the ignition o ...