Units
Once the "Units" menu has been selected, you can change the units of the following parameters:
- temperature (°C or °F),
- fuel consumption (l/100 km, mpg or
km/l).
Once the fuel consumption units have been set to mpg, the information in the instrument panel screen on speed and distance will also be in mph and miles.
For safety reasons, confi guration by the driver of the multifunction screen must only be done when stationary.
See also:
Tyre pressure sensors
This function alerts you in the event of a tyre being deflated or punctured.
For this purpose, sensors continuously monitor the condition of the vehicle’s wheels.
This system does not absolve the ...
Operating faults
If there is an operating fault, when
reverse gear is engaged the service
warning lamp comes on, accompanied
by an audible signal (short beep) and a
message on the multifunction screen.
In bad or ...
Diesel injection equipment
Protective cover for HDi 138 engines:
Remove the protective cover by first unclipping at 3, then 1 and 4.
Unclip at 2 by pulling towards you, then lift up.
To refit the protective cover, firstly ...