Lighting rheostat
System for manual adjustment of the brightness of the instruments and controls in relation to the exterior brightness.
Activation
When the lighting is on:
- press the button to change the brightness of the instruments and controls,
- when the level of brightness required is reached, release the button.
Deactivation
When the lighting is off, or in day mode on vehicles fi tted with daytime running lamps, pressing the button does not have any effect.
See also:
Access to the tools
The towing eye is installed in the boot
under the fl oor.
To gain access to it:
open the boot,
raise the fl oor,
remove the polystyrene storage box,
remove the towing eye from the
hold ...
Programming
Turn thumb wheel 1 to the
"CRUISE" position: the cruise
control mode is selected but is
not switched on (PAUSE).
Set the programmed speed by accelerating
to the required speed,
then ...
Operating faults
If there is an operating fault, when
reverse gear is engaged the service
warning lamp comes on, accompanied
by an audible signal (short beep) and a
message on the multifunction screen.
In bad or ...